WEST CONSHOHOCKEN, PA USA – According to recent studies, the government-mandated CAFE standards for the automotive industry will conserve natural resources and minimize the global carbon footprint. In addition, consumers can expect to save an average of $8,000 over the lifetime of the vehicle once the standards reach full effect. Automobile manufacturers are now scrambling to find innovative solutions to deliver better fuel economy and lower emissions, while consumers are looking for ways to pocket some savings especially as gas prices continue to rise. One part of the solution is the design of smaller, higher power output engines paired with higher efficiency transmissions. The materials specified in the critical components of these engines and transmissions must be able to handle extremely aggressive, high temperature environments. Lightweight VICTREX™ PEEK polymers have more than 30 years of proven success in replacing metals and other polymers in the most demanding conditions.
The increased demands of smaller higher power engines can also lead to greater levels of noise, vibration, and harshness (NVH), but it is possible to combat these factors by designing parts with VICTREX PEEK polymers. According to a case study performed by Metaldyne, a leading global designer and supplier of powertrain components and assemblies, replacing metal with VICTREX PEEK in a balance shaft module lowered NVH by 3dB, which is equivalent to a 50% noise level reduction. “Along with decreasing NVH, we were able to achieve a 30% reduction in system inertia leading to an improvement of up to 9% in power consumption due to the lightweight nature of the polymer,” said Aaron Clark, Engineering Manager for Metaldyne Powertrain Products.
Compared to metals, VICTREX PEEK polymers provide up to 80% in weight savings in powertrain components such as seal rings, thrust washers, bushings, bearings, shift fork wear pads, and gears. These weight savings, paired with a low coefficient of friction and low wear rate, and excellent corrosion resistance can improve the overall efficiency of the transmission. The reduced stress on components and lower friction leads to greater fuel economy, lower maintenance costs, and can increase the lifetime of the powertrain. High performance VICTREX PEEK thermoplastics also offer many other benefits including dimensional stability at temperatures over 200°C (392°F), excellent corrosion resistance to automotive fluids, and the ability to withstand temporary loss of lubrication, all of which can extend part service life especially as manufacturers are offering more aggressive extended warranties to differentiate from competition.
Victrex proactively addresses the demands of the automotive industry with its latest development of VICTREX WG™ polymers as a response to the need for minimal frictional losses and improved wear resistance in critical automotive components. These wear grades have a lower coefficient of friction and reduced wear rate compared to other polymers such as polyimide (PI) and polyamide-imide (PAI), which leads to greater reliability and increased energy efficiency. VICTREX WG polymers can be processed on standard injection molding machines reducing processing costs and part-to-part variability compared to other polymers. VICTREX PEEK also allows parts consolidation and other design improvements which can significantly reduce assembly time and lower the total system cost.
Metaldyne is a leading global designer and supplier of components and assemblies for powertrain applications including engine connecting rods, transmission valve bodies, differential gears and pinions, differential assemblies, balance shaft modules, crankshaft dampers, and crankshaft pulleys. Backed by flexible, high-volume production capabilities, Metaldyne provides design-to-launch solutions that reduce cost, weight, cycle time, and complexity while improving vehicle performance. For more information, visit http://www.metaldyne.com.